Custom formulated thermoplastic powder coatings
for the finishing industry.

Technical Data Sheet
Ph: 814-456-1243 • Fax: 814-459-2853
www.thermoclad.com

DURALON J, JE & JM - Type 11 Nylon
Color Range Unlimited
Specific Gravity 1.04 (Approximately)
Hardness, Shore D 70-75
Tensile Strength, psi 6000 - 9000
(ASTM D-638)
  
Elongation 20% Minimum
(ASTM D-638)
  
Modulus Of Elasticity, psi 2.1 x 105
Dielectric Strength, v/mil 1400 @ 15 mils
Abrasion Resistance 20 MG/5000 Cycles
C/S 10 wheel 1000 gm load
  
Average Particle Size Duralon J
Fluidbed Grade)		 140 Mesh +/- 10

105 Micron +/- 10
Average Particle Size Duralon JE
ElectrostaticGrade)		 230 Mesh +/- 10

63 Micron +/- 10
Melting Point 376º F
Water Absorption at 68º F 1.05%
(65% RH to equilibrium)
Water Absorption at 68º F 1.85%
(in water to equilibrium)
Weathering Very good in white, black, and pastel colors
Salt Spray No corrosion after 2,000 hours

CHEMICAL RESISTANCE:

In general, good resistance to mineral salts, alkalies, most solvents and organic acids. Caution must be observed in uses involving mineral acids, phenols and certain chlorinated solvents. In such cases, it is advisable to carry out a testing program to determine the suitability of the application.

The above properties are based upon tests and data believed to be reliable, since actual use by others is beyond our control, no guarantee, expressed or implied is made by The Thermoclad Company as to the effects of such use or results to be obtained.